Dimas FS 350 Manual del operador descargar pdf (Pagina 38)

English

A reversible and removable cutting guide enables

45° to 90° cuts to be made.

This cutting guide is machined in such a way that

it can be fitted in several positions in addition to its

right angle position from 0° to 45° to the left or to

the right.

Cutting method9

• Straight cuts (SEE FIG 14)

≤ 570 mm : the stop (C) prevents fingers

being trapped between the table and the

frame (SEE FIG 15).

> 570 et ≤ 650 mm : retract the stop (C)

under the table to increase the stroke.

Depth of cut adjustment10

Maintenance (the motor must be stopped)

Store in a dry place, not accessible to

children.

Maintain the tools carefully.

• Clean the machine regularly.

• Drain the tank (22) frequently to remove cutting

residue, which otherwise could block the pump

and cause it to wear out prematurely. (SEE FIG

17)

• Swill out the tanks (1) and (22) with water.

• Carefully clean the contact faces for the table

rollers.

FAULT FINDING

In the event of faulty operation refer to the tables

below to find a solution.

CAUSES

• The machine does not work

Not plugged in proper-

ly or cable damaged

No mains voltage

Switch defective,

motor cable damaged

Motor faulty (no

power, unpleasant

smell)

- Make sure that the

supply is correctly

plugged in (plug,

extension lead, etc)

- Check the supply

cable

- Test or have tested

by an electrician (cir-

cuit breaker, plug,

etc)

- Have tested by an

electrician or contact

the service depart-

ment

- Contact the service

department to have

the motor replaced

REMEDIES

CAUSES

REMEDIES

• Difficult starting

Single phase motor

starting condenser

Three-phase supply

not correct (on 2

phases, motor cable

faulty)

- Replace the

condenser

- Have it checked by

an electrician or

contact the service

department

CAUSES

REMEDIES

• The pump does not start

The mains lead is not

correctly connected or

is damaged

No voltage in pump

circuit or mains supply

circuit

- Check the mains

lead

- Check the pump cir-

cuit and mains sup-

ply circuit

REMEDIES

• The pump does not pump water

CAUSES

An air bubble may

have formed inside the

pump body

The turbine is jammed

- Holding the pump of

the outlet pipe remove

it from the water and

reimmerse it

- Unscrew the filter

and, using a small

screwdriver, remove

all dirt from the ope-

rating area of the tur-

bine.

(SEE FIG. 16)

•

Slacken off handle (6).

•

Use lever (5) to adjust the cutting height.

•

Tighten handle (6).

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 67 68

Comentarios a estos manuales

Sin comentarios

Dimas FS 350 Manual del operador Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Sierras circulares Dimas FS 350